Notification

Icon
Error

How to run a report

Posted: Tuesday, November 18, 2014 5:20:44 PM(UTC)
Susan.A

Susan.A

Member Administration Original PosterPosts: 1,535
8
Like
To run any of the reports found in the report center, do the following:
  • Open the report builder in the Lansweeper web console under Reports/Create New Report.
  • Paste the SQL query (report) found in the report center at the bottom of the page, replacing the default SQL query.
  • Left-click somewhere in the upper section of the page so the query applies.
  • Give the report a title.
  • Hit the Save & Run button to save the report. Export options are listed on the left.
Additionally, you can find a detailed explanation here: https://www.lansweeper.c...lansweeper-installation/

Active Discussions

Lansweeper Moving Assets in Location not Saving
by  brodiemac   Go to last post Go to first unread
Last post: Today at 6:16:39 PM(UTC)
Lansweeper Deployment condition
by  Florian  
Go to last post Go to first unread
Last post: Today at 11:58:51 AM(UTC)
Lansweeper lsagent not scanning/sending when using relay
by  Esben.D   Go to last post Go to first unread
Last post: Yesterday at 12:31:02 PM(UTC)
Lansweeper Check if Netbios is disabled over TCP/IP
by  TaherMD  
Go to last post Go to first unread
Last post: Yesterday at 6:00:51 AM(UTC)
Lansweeper Email attachments
by  krejar   Go to last post Go to first unread
Last post: 8/15/2019 10:15:07 PM(UTC)
Lansweeper HP Printer not showing correctly
by  Fathom  
Go to last post Go to first unread
Last post: 8/15/2019 4:14:55 PM(UTC)
Lansweeper Install LsAgent on Mac
by  Jonnym   Go to last post Go to first unread
Last post: 8/14/2019 10:14:08 AM(UTC)
Lansweeper Asset State Question
by  rtaylor  
Go to last post Go to first unread
Last post: 8/13/2019 5:53:24 PM(UTC)