Notification

Icon
Error

New asset state "Replaced"

Posted: Thursday, December 5, 2019 10:32:12 AM(UTC)
JB

JB

Member Original PosterPosts: 1
0
Like
Hi,

I also wrote an email to the support team, but will put the request here for general discussion.

Here's the request:

it would be very useful, if an asset could get a state of „Replaced“. It would be even more useful, if there would a be possibility to link to the new asset that replaced the old one.

Regards
JB
wdobson
#1wdobson Member Posts: 2  
posted: 1/14/2020 10:32:52 PM(UTC)
Hello JB,

Not sure if you ever got your response for this item, if not I may be able to help you.

You should be able to add custom asset states under the configuration tab > Asset Management > Asset Pages > Asset States. I have used a "Replaced" state for some time now. I would recommend when you change an asset to the Replaced state, also remove the IP address for that asset on its page. This should prevent any confusion later down the road.

Additionally, you can use a custom Relational Mapping also under the configuration tab > Asset Management > Relational Mapping. From there, go back to either the replaced asset or replacement, and add the relation on the asset page. This will allow you to document the replacement and provide a direct hyperlink to the attached asset.

Hope this helps.


Originally Posted by: JB Go to Quoted Post
Hi,

I also wrote an email to the support team, but will put the request here for general discussion.

Here's the request:

it would be very useful, if an asset could get a state of „Replaced“. It would be even more useful, if there would a be possibility to link to the new asset that replaced the old one.

Regards
JB


Active Discussions

Lansweeper Asset Out of Warranty & Asset Out of Warranty in 60 Days Reports
by  RC62N   Go to last post Go to first unread
Last post: Yesterday at 10:29:35 PM(UTC)
Lansweeper Voip Phone to Computer
by  lansend  
Go to last post Go to first unread
Last post: Yesterday at 1:27:10 AM(UTC)
Lansweeper Report Showing custom registry keys scanned
by  impagian   Go to last post Go to first unread
Last post: 1/23/2020 4:01:34 PM(UTC)
Lansweeper Dell Update v3.0
by  gmw158  
Go to last post Go to first unread
Last post: 1/22/2020 5:42:19 PM(UTC)
Lansweeper Report to compare softwareVersion
by  RC62N   Go to last post Go to first unread
Last post: 1/22/2020 4:57:16 PM(UTC)
Lansweeper Dublicate entries (multiple lines with assetname)
by  wkorrubel  
Go to last post Go to first unread
Last post: 1/22/2020 10:10:28 AM(UTC)
Lansweeper Only show string right of character N
by  RC62N   Go to last post Go to first unread
Last post: 1/20/2020 10:36:12 PM(UTC)
Lansweeper Report From Lansweeper For My Company
by  RC62N  
Go to last post Go to first unread
Last post: 1/17/2020 6:59:47 PM(UTC)