cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Ithd
Engaged Sweeper
Hi

i have some device (example: HP thin client) that i can't find in the asset

For me it's not a problem but i need almost that the ip are in use

where i see it?


Thanks
1 ACCEPTED SOLUTION
Daniel_B
Lansweeper Alumni
Thin clients are scanned best with SNMP. You might need to enable SNMP directly on the target systems. Afterwards scan them following the instructions in this article.

In case you are scanning network devices which don't provide any of the protocols mentioned here, you could enable "Save Ping IP" under Configuration\Scanning methods, section IP Address Range scanning. This causes Lansweeper to generate an asset page for devices which only replied to ping.

View solution in original post

1 REPLY 1
Daniel_B
Lansweeper Alumni
Thin clients are scanned best with SNMP. You might need to enable SNMP directly on the target systems. Afterwards scan them following the instructions in this article.

In case you are scanning network devices which don't provide any of the protocols mentioned here, you could enable "Save Ping IP" under Configuration\Scanning methods, section IP Address Range scanning. This causes Lansweeper to generate an asset page for devices which only replied to ping.