cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
ghelpdesk
Champion Sweeper
Hi,

Just seeking some clarification/information on how the 'after scanning' execution plan works. The deployment information page here does not appear to explain it in detail --> http://www.lansweeper.com/kb/109/deploying-a-package-manually-or-based-on-a-schedule.html

We are running version 5.2.0.42 and I think there may be an issue with 'after scanning' but perhaps we are misunderstanding its operation?

Does this process run aftger every asset is scanned and if on the report, group or manual selection it will then run always? if the asset is then scanned again (ie: 20 mins later) but still appears on the selection list is it intended to run again? or perhaps not run again until the following day?

Many thanks,
1 ACCEPTED SOLUTION
Bert_D
Lansweeper Employee
Lansweeper Employee
Lets say you have a group of after scanning assets => As1, As2, As3

When you scan As1, it will deploy only on As1
When you scan As2, it will deploy only on As2
When you scan As1 & As2, it will deploy on both As1 & As2

If As3 is never scanned it will also not deploy on that asset.

View solution in original post

6 REPLIES 6
ghelpdesk
Champion Sweeper
Thanks Bert.
Bert_D
Lansweeper Employee
Lansweeper Employee
Lets say you have a group of after scanning assets => As1, As2, As3

When you scan As1, it will deploy only on As1
When you scan As2, it will deploy only on As2
When you scan As1 & As2, it will deploy on both As1 & As2

If As3 is never scanned it will also not deploy on that asset.

ghelpdesk
Champion Sweeper
No worres Bert. Would it be possible to have the process of after scanning clarified as well please? Should it run after every scan of any asset that is listed on the schedules selection settings?

Thanks
Bert_D
Lansweeper Employee
Lansweeper Employee
I would recommend you update to the latest version (5.3.x.x).
Most likely this will fix the issue you are experiencing.
Download link : http://www.lansweeper.com/Download.aspx

Since upgrading is free, we do not offer support for older versions.
ghelpdesk
Champion Sweeper
The issue we are finding is that it will run once but then never again for other assets that appear in the selection group (via report or dynamic group) unless we untick/tick enable for the schedule which seems to reinitialise the schedule but then, only for 1 more pass.
servicedesk
Champion Sweeper II
hi

To avoid this I set the option "rescan asset" in the desired deployment package.